Moon Phases Necklace

Design by Gea

Moon:
Cut in half the blanks (possibly with a metal saw or easier with a whisk) and refine the tag with sand paper.
Then muss it in the way that it borders would't remain sharp.
Place the bottom of the blanks inside the doming block to circle it lightly.
Than do the same with the circular blanks.
Always using the doming block as a base, work three blanks with the flat end of the hammer in order to create a texture.
Replicate the texture operation on the stainless steel blanks.
Use the hole punch at the top of the blanks, than insert a tiny ring.

Necklace:

Cut the beading wire and close one end with a crimp and a wire protector.
Then start the sequence by lining 14 pearls, 2 rocailles, the crescent moon, again 2 rocailles, and 5 pearls.
Than1 rocailles, half moon and 1 rocailles.
Continue with another rocailles, 6 pearl, 1 rocailles, the full moon and another rocailles.
Complete the sequence from the other side to the end.
Once the beading wire is closed, use couple of tiny rings to assemble the clasp at the end of the wire savings.